Calima, dust and leaves: keeping a Spanish villa pool clean

If you’ve owned a villa on the Costa del Sol for more than a few months, you’ll have met calima: the hazy, orange-tinted sky when Saharan dust blows over southern Spain, and the fine brown film it leaves on cars, terraces and, of course, the pool. Add pine needles, bougainvillea petals and the odd storm, and keeping a Spanish villa pool clean becomes a year-round job.

Community pool in a residential development on the Costa del Sol
A community pool on the Costa del Sol (Málaga). Photo: piscina365.es

I’m David Young and I write from the Costa del Sol (Málaga). I haven’t measured how much dust any filter or robot catches. This guide is built on official sources: AEMET (Spain’s state weather agency) for calima, ESPA (a Spanish pump manufacturer) for cleaning up after dust, and robot manufacturers’ spec pages for filtration. Everything is linked at the end.

What calima is and how often it happens

AEMET says that Saharan mineral dust intrusions recur frequently in our geographic area. A study cited on AEMET’s blog (Díaz et al., 2017, using 2004 to 2009 data) found Saharan dust on 30.1 % of days in south-east Spain, compared with 18.2 % in the centre and 9.6 % in the north-west. That figure counts days with dust advection, not days with a visible muddy pool. On the peninsula, these intrusions can happen at any time of year but are most frequent in June, July and August and least frequent in winter.

The particles vary a lot in size. An AEMET observatory paper on mud rain in Murcia describes Saharan dust particles from under one micron to over 10 microns, sometimes reaching around 250 microns. That range explains why some of it settles quickly and some stays suspended and makes the water cloudy. When dust falls with rain, you get «mud rain» (lluvia de barro): rain carrying mineral dust, which leaves a muddy layer.

You can check the forecast on AEMET’s mineral dust page, which publishes daily probability maps of surface dust concentration for the Iberian Peninsula and Balearics, based on models from the Barcelona Dust Regional Center run by AEMET and the Barcelona Supercomputing Center.

Why your robot alone won’t fix it

A robot vacuums, brushes and returns water to the pool through its filter. Anything smaller than its mesh goes straight back into the water. Most robot baskets are around 150 to 180 microns; some add an ultra-fine filter of about 3 microns. Given the particle sizes AEMET describes, a coarse basket lets a lot of fine dust through.

ESPA goes further: in its guide to cleaning a pool after Saharan dust, it says not to use automatic or hydraulic cleaners for the heavy mud, because they make the problem worse. The fine mud passes through the filter, so it recommends vacuuming to waste instead.

Summary table: what to do and when

Stage What to do Why
While dust is falling Cover the pool if you can; empty skimmer baskets Less dust gets in; skimmers keep working
Straight after Test chlorine and pH; wash the filter ESPA’s first steps
Next 24 to 48 hours Let the mud settle ESPA says the heavy mud sinks without flocculant
Heavy layer on the floor Vacuum to waste with a manual cleaner Fine mud would pass through the filter
Fine residue left Run the robot with its finest filter; empty it mid-cycle if needed A 3-micron filter catches far more than a coarse basket

Step by step after a calima episode

1. While it’s still falling

Don’t start a deep clean while dust is still coming down: you’ll just stir it up and load your filter. If you have a cover, use it. Empty the skimmer baskets so water can keep flowing.

2. Test the water and wash the filter

ESPA’s first step is to check chlorine and pH. Then it recommends a filter wash, filtration for 24 to 48 hours, and a final filter wash. Follow your own filter’s manual, and stop the pump before turning the selector valve.

One honest caveat: ESPA’s guide isn’t entirely consistent. It describes running filtration for 24 to 48 hours, but its tips also say that if you run your pump daily, you should stop it for a few days and let the dust settle. Both aim to avoid overloading the filter with fine dust. If your filter pressure rises sharply, backwash rather than keep filtering blindly.

3. Let it settle

According to ESPA, after 24 to 48 hours the heavy mud sinks to the bottom without flocculant and the water clears. ESPA advises against adding flocculant at this stage. Don’t swim or stir the water while it settles.

4. Vacuum heavy mud to waste

If there’s a thick layer, ESPA’s method is to stop the pump, disconnect the salt chlorinator if you have one, and set the valves so that only the cleaning (vacuum) line is open and the selector is on empty or drain. Then restart the pump and vacuum slowly with a manual cleaner, sending the dirty water to drain, not through the filter. Afterwards, stop the pump, return the valves to filtration and reconnect the chlorinator. Top up the water, because you’ve been emptying the pool.

Valve labels vary between installations. If you’re not sure, ask your pool man rather than improvise. Many above-ground pools don’t have a drain setting at all.

5. Finish with the robot and its finest filter

Once only a fine residue is left, the robot comes into its own. Use the finest filter it accepts. For example:

  • Aiper Scuba S1: 180-micron basket plus a 3-micron MicroMesh filter, according to Aiper.
  • Aiper Scuba X1: 5-litre basket plus a MicroMesh filter of 3 microns on the spec page and 3 to 10 microns in the manual. Aiper recommends using it when there’s little visible debris and the water is cloudy, and not when there are lots of leaves or sand.
  • Beatbot Sora 10: 150-micron filter; Beatbot sells a 3-micron ultra-fine basket separately.
  • WYBOT S2: 180-micron basket with a foam layer.

Empty the basket mid-cycle if it fills up, and rinse ultra-fine filters well afterwards. Aiper lists its filters, including the MicroMesh, as consumables with a 3-month usage period in its Spanish warranty policy. Our guide to the best cordless robot pool cleaners for villas in Spain compares filtration in more detail.

Check current price

Leaves, pine needles and petals

Dust isn’t the only problem. Villas with pines, palms, jacaranda or bougainvillea get a steady fall of debris, especially in windy weather. A few practical points:

  • Skim first. Most robots don’t clean the surface, so floating leaves need a net or your skimmers. Among cordless robots, the Beatbot AquaSense 2 Pro is one that also skims the surface, according to Beatbot.
  • Basket size matters. The Beatbot Sora 10 and Aiper Scuba X1 both have 5-litre baskets, according to their manufacturers.
  • Don’t use an ultra-fine filter for leaves. Aiper advises against using its MicroMesh when there are lots of leaves or sand, because it clogs.
  • Empty skimmer and pump baskets often. A clogged basket starves the pump.
  • Check brushes and tracks. Pine needles and hair can tangle in them. Beatbot’s pre-winter cleaning guide asks you to remove tangled hair, string and twigs from roller brushes and tracks.

Water chemistry after dust or leaves

Dust and decaying leaves use up chlorine. Test pH and chlorine after any episode and correct them following the product labels. If you have a salt chlorinator, remember that ESPA asks you to disconnect it while you vacuum to waste. Our guide to salt chlorinators in Spain covers pH and salt levels.

If you’re not there

Calima often arrives when owners are away. Agree with your pool man what happens after an episode: a check of filter pressure, a backwash, and vacuuming to waste if needed. Our guides to leaving your Spanish pool while you’re away, robot pool cleaner or pool man and villa pool maintenance on the Costa del Sol go into more detail.

FAQ

Can I just run my robot after calima?

Not for heavy mud. ESPA advises against using automatic or hydraulic cleaners for it, because fine mud passes through. Vacuum to waste first, then use the robot with its finest filter for the residue.

Should I add flocculant?

ESPA says not to, and to let the dust settle on its own. If the water is still cloudy afterwards, follow the product label carefully.

When is calima most common?

According to the study cited on AEMET’s blog, Saharan dust intrusions on the peninsula are most frequent in June, July and August and least frequent in winter, though they can happen at any time.

Where can I check if calima is coming?

AEMET publishes daily mineral dust probability maps for the Iberian Peninsula and Balearics.

Which robot filter is best for dust?

The finest one your robot accepts. Aiper’s Scuba S1 and X1 have 3-micron MicroMesh filters, and Beatbot sells a 3-micron basket for the Sora 10.

Sources

Disclosure: piscina365.es takes part in affiliate programmes, including the Amazon EU Associates Programme. If you buy through our links we may earn a commission at no extra cost to you.

Publicaciones Similares

Deja una respuesta

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *