Salt water pools in Spain: what owners need to know about salt chlorinators

If you have bought a villa or holiday home on the Costa del Sol, there is a good chance the pool already runs on salt. Salt chlorinators (in Spanish, clorador salino or electrólisis salina) are everywhere in Andalucía, and plenty of new owners inherit one without really knowing how it works. This guide explains what a salt chlorinator does, what it doesn’t do, and what you need to keep an eye on as an owner, especially if you are not here all year.

Pool with palm trees and sea views on the Costa del Sol
A pool with sea views on the Costa del Sol (Málaga). Photo: piscina365.es

I’m David Young and I write from the Costa del Sol (Málaga). I haven’t tested any of these units: everything below comes from manufacturers’ manuals and data sheets and from official Spanish sources, all linked at the end. Where two official sources disagree, I say so.

What a salt chlorinator actually does

A salt chlorinator turns dissolved salt into chlorine. Water passes through a cell with electrodes; the electricity splits the salt and produces chlorine, which disinfects the pool, then turns back into salt. So a «salt water pool» is still a chlorinated pool. The difference is that you don’t add chlorine by hand every few days: the chlorinator makes it while the pump runs.

It has two parts: the cell, fitted in the return pipe after the filter, and a control unit on the wall near the pump. The control unit only produces chlorine while water is flowing through the cell, which is why chlorinators are wired to the pump.

What it doesn’t do

  • It doesn’t control pH. In fact, pH tends to rise in salt pools, so you still need to test and correct it, or fit an automatic pH regulator.
  • It doesn’t replace the pump or the filter.
  • It doesn’t clean the floor or the waterline. That is still a job for you, your pool man or a robot.
  • It doesn’t work well in very cold water. Several models reduce or stop production as the water cools (more on that below).

How much salt?

Less than people think, and it depends on the model. Spanish data sheets use grams per litre (g/L); 1 g/L is the same as 1 kg per cubic metre of water, or 1,000 ppm.

Model (official source) Salt level
AstralPool E-Next (leaflet) 4 to 6 g/L
AstralPool Clear Connect (official manual Ver.20251103) 4 g/L recommended (range 3 to 12)
Zodiac eXO iQ (data sheet) 4 g/L (minimum 3.3)
Zodiac GenSalt OE iQ (catalogue) 4 g/L
Hayward Salt and Swim 3C (catalogue) 3 g/L
Bayrol Salt Relax POWER (data sheet) From 1.5 g/L
Intex QS400 (manual) 3,000 ppm (2,500 to 3,500)

One point to watch: a 2024 version of the Clear Connect manual gives 5 g/L as the recommended level, so the figure depends on which manual came with your unit. Always follow your own manual. On the Spanish side of the site we explain how to calculate the exact quantity in our guide to the best salt chlorinators of 2026 (mejores cloradores salinos 2026, in Spanish).

Salt goes into the pool itself, never through the cell. The Zodiac Ei2 iQ manual asks for food-grade common salt (sodium chloride) without iodide or anti-caking agents, added to the pool itself or the compensation tank, away from the main drain.

pH: the thing owners forget

This is where most salt pool problems start. Manufacturers are clear that pH matters both for disinfection and for the cell:

  • AstralPool (Clear Connect) and Zodiac (Ei2 iQ) recommend pH 7.2 to 7.6, and both manuals exclude electrode warranty claims if the pool has been run above pH 7.6.
  • Zodiac’s eXO iQ manual asks for 7.0 to 7.4, with a set point of 7.2.
  • Intex’s above-ground chlorinators recommend 7.4 to 7.6.
  • For public and community pools, Spain’s Royal Decree 742/2013 sets pH 7.2 to 8.0. It applies to community pools (comunidades de propietarios), not to a private single-family villa.

High pH in hard water also leaves scale on the electrodes, so the cell makes less chlorine and wears faster. If your pH keeps creeping up, an automatic pH regulator with an acid dosing pump is worth considering, especially for a holiday home.

On acid choice, the manuals don’t agree. AstralPool and Zodiac ask you to keep the chlorinator away from stored hydrochloric acid and recommend sodium bisulphate or diluted sulphuric acid. Hayward’s Salt and Swim manual, on the other hand, discourages dry acid (sodium bisulphate) in arid regions. Follow your own manual, and handle any acid with gloves and glasses.

Stabiliser (cyanuric acid)

Stabiliser protects chlorine from strong sun, which is useful in Andalucía, but too much makes chlorine less effective. AstralPool’s Clear Connect manual and Zodiac’s Ei2 iQ manual recommend 25 to 30 mg/L in strong sun and never above 75. Intex’s two manuals disagree with each other (10 to 30 ppm for the QS400, 20 to 40 ppm for the QS500 and QS1200). Stabiliser doesn’t evaporate: the only way to lower it is to replace some of the water.

Cold water and winter

Chlorinators produce less in cold water, and some stop completely:

  • Zodiac’s eXO iQ drops to low output at 15 °C and stops at 10 °C or below, restarting automatically when the water warms.
  • Hayward’s Salt and Swim 3C reduces output below 15 °C and stops below 10 °C.
  • AstralPool’s Clear Connect cell works from 15 to 40 °C and can’t reach full output in cold water.
  • Bayrol says the Salt Relax POWER can produce chlorine in water down to 1 °C, with an adjustable winter mode.

Zodiac’s salt pool advice is to switch the electrolyser off below 10 °C. Cold water also lowers the salt reading, so a «low salt» alarm in January doesn’t always mean you need more salt. Test with a separate meter or strips before adding any. Our November to March winterising checklist goes into more detail.

Electrical safety and installation

In Spain, pool electrics are covered by ITC-BT-31 of the Low Voltage Electrical Regulation (Royal Decree 842/2002), which includes residual current protection of no more than 30 mA. The chlorinator manuals I checked (AstralPool Clear Connect, Zodiac eXO iQ and Ei2 iQ) also ask for an RCD of 30 mA, earthing and an accessible isolating switch, and Zodiac’s eXO iQ manual asks for the control box at least 3.5 m from the pool edge. If you are not a qualified electrician, leave the wiring to one.

The cell: life, cleaning and warranty

The cell is the part that wears out. Official figures vary:

Model Electrode life (official) Warranty (official)
AstralPool E-Next 8,000 to 10,000 hours 2 years
AstralPool Clear Connect 8,000 to 10,000 hours Electrodes 3 years or 8,000 h (official manual Ver.20251103; a 2024 manual gave 2 years or 8,000 h)
AstralPool Elite Connect CellGuard Up to 18,000 hours 3 years unit, 5 years CellGuard cell
Zodiac eXO iQ Not published in the data sheet I used 3 years unit and cell
Hayward Salt and Swim 3C Not published in the catalogue 2 years (plus 1 via Totally Hayward dealers)

Hours are production hours, not years. Keeping pH in range, salt at the right level and the cell free of scale all help it last. Many units reverse polarity automatically to reduce scale, but you should still inspect the cell, following the manual.

Salt and your robot pool cleaner

Most robot cleaners work in salt pools, but check the limit. Maytronics gives a maximum of 5,000 ppm for its Dolphin robots, and the Aiper Scuba X1 manual also gives 5,000 ppm. Beatbot lists the Sora 10 as compatible below 5,000 ppm. That covers the usual 3 to 5 g/L. We cover this in our guide to the best robot pool cleaners for Costa del Sol villas.

Holiday homes: what to set up before you leave

  • Check salt, pH and stabiliser before you go, and correct them.
  • Make sure the chlorinator runs only with the pump, and that the pump timer gives enough filtration hours.
  • If you are away for weeks, an automatic pH regulator saves a lot of trouble.
  • Ask your pool man to check the chlorinator display on each visit and send you a photo of any alarm.

More in our guide to leaving your Spanish pool while you’re away and in villa pool maintenance on the Costa del Sol.

Check current price

FAQ

Is a salt water pool chlorine-free?

No. The chlorinator makes chlorine from the salt. You just don’t add it by hand.

How salty is the water?

Typically 3 to 5 g/L, depending on the model, though Bayrol’s low-salt units work from 1.5 g/L. Follow your own manual.

Why does my pH keep rising?

It is a well-known effect of salt pools. Test regularly and correct it, or fit an automatic pH regulator. Several manufacturers exclude warranty claims if the pool runs above pH 7.6.

Should I switch the chlorinator off in winter?

It depends on the model. Zodiac advises switching the electrolyser off below 10 °C, and some units stop by themselves at that temperature. Check your manual.

Can I install a salt chlorinator myself?

The plumbing is within reach of a competent DIYer, but the electrics must meet ITC-BT-31, including 30 mA protection. Use a qualified electrician if in doubt.

Sources

Disclosure: piscina365.es takes part in affiliate programmes, including the Amazon EU Associates Programme. If you buy through our links we may earn a commission at no extra cost to you.

Publicaciones Similares

Deja una respuesta

Tu dirección de correo electrónico no será publicada. Los campos obligatorios están marcados con *